Elevator Tractor,Gearless Traction Machine Motor

Elevator Traction Machine

Hotline
Products

DC180X Traction Machine

BASIC INFO
DC180X Elevator Traction Motor, Lift Traction Machine
 

Traction ratio: 2:1 steel wire rope suspension
Brake opening: DC200V / DC1.9A
Brake holding: DC100V / DC0.9A


DC180X elevator traction machine
DC180X elevator tractor motor

Technical parameter:

Rated load kg Rated speed m/s Rated torque N.m Rated power kw Rated current A Rated voltage v Rev (r/min) Rated frequency Hz Diameter mm Groove mm Groove spacing mm Max. shaft load kg
250 0.25 102 0.42 0.95 380 40 10 Φ240 4*8 13 2500
1.7 220
0.4 0.67 1.4 380 62 15.5
2.4 220
0.5 0.85 1.7 380 80 20
2.9 220
320 0.25 130 0.54 1.4 380 40 10
2.4 220
0.4 0.86 1.9 380 62 15.5
3.3 220
0.5 1.1 2.3 380 80 20
4.0 220
400 0.25 162 0.7 1.8 380 40 10
3.2 220
0.4 1.1 2.5 380 62 15.5
4.4 220
0.5 1.4 3.0 380 80 20
5.2 220
450 0.5 182 1.5 3.3 380 80 20
5.8 220
0.63 1.9 4.0 380 100 25
7.0 220
1.0 3.1 6.1 380 160 40
10.6 220
DC180X elevator tractor machine
The gearless traction machine is provided with a disc brake that is operated by 2 independent electromechncial devices which are conform to the EN81-1 standard.
The gripping callipers are pre-calibrated by the manufacturer and therefore don’t require any further adjustment.
Attention must be paid and if necessary precautions taken to ensure that oil or grease do not come into contact with the brake disc.
Grease or oil on the brake disc can affect the braking and put people in serious danger.
The gearless traction machine does not contain oil and is supplied with bearings that are lubricated for the life of the equipment, therefore no further lubrication is necessary.
The motor power connector are the clamps u1, v1, w1. The microswitch brake contacts connected at the terminal block are normally open contacts as default.
The microswitch has two contacts, one for NO and one for NC. When the lift is stopped, the brake of the gearless motor is closed. In this situation, the whole lift has no movement. When the motor receive the command to move, the brake as well as the micro switch changes its status from CLOSED to OPENED.
 

Maintenance


Traction/Driving Wheel
Periodically, at least once a year, check the amount of wear on the cable races on the traction wheel. In the event of the cables slipping or of excessive wear, contact Suntous for the replace instructions, always indicating the serial number.

Component Replacement
The instructions for any eventual component replacement must be asked for each time from the Techncial Department, specifying the serial number.
Previous :
Next:

Online Inquiry

X

Online Chat

  Email me